MER GROUP: Brief Working Principle of Double Shaft Kiln


The core structure of the double shaft kiln consists of two interconnected vertical chambers (Chamber A and Chamber B). The kiln adopts an overall vertical layout with a small floor area. The bottoms of the two chambers are connected by passages, and a reversing device is installed at the top to realize periodic functional switching of the two chambers. The middle section of the kiln serves as the calcination zone, with a discharging device at the bottom and feeding and smoke exhausting equipment equipped at the top. Its core design achieves efficient heat utilization through alternate calcination and heat storage recovery, with a thermal efficiency of over 80%.
Its working principle is based on the logic of dual-chamber coordination and periodic reversing. The operation process is divided into two alternating cyclic stages, with each cycle normally lasting 8–12 minutes:
Stage 1 (Chamber A for calcination, Chamber B for preheating/cooling)
Fuel is injected and combusted through the burners at the lower part of Chamber A, generating high-temperature flue gas at 1200–1300℃. The high-temperature flue gas flows upward along Chamber A to calcine and preheat the limestone fed from the top, enabling gradual decomposition reaction of limestone. Afterwards, the high-temperature flue gas passes through the connecting passage at the top of the two chambers into the lower part of Chamber B, continuing to preheat the limestone inside Chamber B and completing the first recovery of flue gas waste heat.
Meanwhile, cold air enters from the top of Chamber B and flows downward to cool the quicklime that has completed calcination in Chamber B. After absorbing the sensible heat of quicklime, the cold air is heated into hot air, which is sent into Chamber A through the bottom passage as combustion-supporting air, realizing the secondary recovery of sensible heat. At the end of this stage, the calcined quicklime in Chamber A is discharged from the bottom, and the materials in Chamber B finish preheating.
Stage 2 (Chamber B for calcination, Chamber A for preheating/cooling)
The reversing device switches the functions of the two chambers. Fuel is then injected and combusted from the lower part of Chamber B. High-temperature flue gas flows upward along Chamber B to calcine materials, and then enters Chamber A to preheat newly fed limestone. Cold air enters from the top of Chamber A to cool the finished quicklime in Chamber A, and the heated hot air is used as combustion-supporting air for Chamber B.
Through such periodic alternation, the two chambers continuously circulate the function of calcination – preheating/cooling to realize continuous production. Throughout the whole process, flue gas heat and sensible heat of quicklime are fully recovered and utilized, greatly reducing the heat consumption per unit product.